|
Post by pj1234b on Aug 15, 2022 8:20:39 GMT -5
I am at the end of my knowledge of getting my 66' started. New plugs wires, fuel filter, rotator, ignition cap, points, condensor, carb rebuild. I admit first time rebuilding carb. Pump is getting fuel up to carb.
I have spark but I cannot get it to fire even with ether. Could timing be that far off and why it cannot fire up? Seems to line up with where it should be.
Wondering if anyone is around in the Hudsonville area to give a pointer or 2? IF not, throw out some ideas for me to check.
289, 2bbl 1966.
|
|
|
Post by thunderfoot1992 on Aug 15, 2022 14:45:32 GMT -5
It's possible your timing could be 180 degrees out. Did you pull the distributor out when you did the overhaul?
|
|